Re: RG 30-30 cast bullets and mold
Posted: 21 Sep 2015 18:08
RD, I doubt I would be the only one that would giggle with glee if you were to post data for that custom mold. Not that I also ordered one.
Rossi Rifleman
The Forum for the Rossi Enthusiast! This site is not associated with RossiUSA/Braztech nor is RossiUSA/Braztech responsible for this site's content.
http://rossi-rifleman.com/
RG 30-30 cast bullets and mold
Page 3 of 3
Re: RG 30-30 cast bullets and mold
Posted: 21 Sep 2015 22:00
I did get my bullet mold on Saturday but it is gon'na be a real good while before I can work with it. Sometime this winter at the earliest.
Re: RG 30-30 cast bullets and mold
Posted: 30 Oct 2015 09:36
Years ago I had more money than patience. Now it's the opposite so waiting for a winter break doesn't sound so bad. 
Re: RG 30-30 cast bullets and mold
Posted: 07 Nov 2015 17:36
don't think so much of it as max pressure but where the max pressure occurs and where the boolit is at the time.
if it hits 6" down the barrel the bullet is moving and it's fully supported by steel.
not much damage can happen at that point [except maybe some gas cutting]
if it's happening in the throat where the bullet isn't so supported and the gas can surround it then you increase the chances of damage or blow-bye.
if it hits 6" down the barrel the bullet is moving and it's fully supported by steel.
not much damage can happen at that point [except maybe some gas cutting]
if it's happening in the throat where the bullet isn't so supported and the gas can surround it then you increase the chances of damage or blow-bye.