Rossi Rifleman

what size pin punches needed for the R92 disassembly?

never mind, 3/32 will do

mr surveyor wrote:never mind, 3/32 will do

If you change the safety out to a Steve Gunz safety plug you will also need a 1/16".

sorry I don't really have an answer I just find a punch that fits and use it never actaully looked at the size of what I was using.

Ya'll use punches??????

what I use

joec wrote:

mr surveyor wrote:never mind, 3/32 will do

If you change the safety out to a Steve Gunz safety plug you will also need a 1/16".

where you been Joe?

donhuff wrote:

joec wrote:

mr surveyor wrote:never mind, 3/32 will do

If you change the safety out to a Steve Gunz safety plug you will also need a 1/16".

where you been Joe?

Getting over Bacterial Pneumonia since new years day. I do have my 92 454 close to being done though as I finally got the forearm band to fit but still finishing the wood on it.

joec wrote:Getting over Bacterial Pneumonia since new years day. I do have my 92 454 close to being done though as I finally got the forearm band to fit but still finishing the wood on it.

Sorry to hear you've been down sick Joe. My prayer continue for you.

I keep lots of hilti nails and studs on hand, the hard ones for shooting in steel and concrete. I grind the end to the size I need and only about 3/16 long so it don,t bend to start the stubburn pin moveing. u can then
use nails , welding rods ect.
Louis

mr surveyor wrote:what size pin punches needed for the R92 disassembly?

donhuff wrote:Ya'll use punches??????

what I use

REDNECK...... Bet you also use bailing wire and Duct tape..... So do I.