How much metal to take off??

lago · Post by **lago** » 18 Dec 2013 18:27

Got Steve's video and ready to start BUT don't want to take off too much metal. Example-how much do you take off the extractor. It looks like about half but just guessing.

Anybody recall?

Thanks

Lago

akuser47 · Post by **akuser47** » 18 Dec 2013 19:04

if you follow his video it will show the basic shape in which you need to grind it I didn't measure or weigh it I did it till it ejected were I want them. so remove some test it and see how it is.

Tuco Ramirez · Post by **Tuco Ramirez** » 18 Dec 2013 20:47

akuser47 wrote: so remove some test it and see how it is.

once it off it does not go back on. Take your time and go easy.

Fullthrottle · Post by **Fullthrottle** » 22 Dec 2013 01:21

akuser47 wrote:if you follow his video it will show the basic shape in which you need to grind it I didn't measure or weigh it I did it till it ejected were I want them. so remove some test it and see how it is.

This exactly!
Remove a little and try, repeat if needed, as many times as needed!

donhuff · Post by **donhuff** » 22 Dec 2013 20:20

I don't have the DVD. Why are you guys taking metal off of the extractor?

akuser47 · Post by **akuser47** » 22 Dec 2013 20:26

donhuff wrote:I don't have the DVD. Why are you guys taking metal off of the extractor?

It helps to stop the brass from going into lunar orbit they land all right at my feet and chew the rim alot less. In short saving your brass.

donhuff · Post by **donhuff** » 23 Dec 2013 15:57

OK, so that it's not so hard to snap over the rim?

anybody have a picture of one done like that? I would like to try it, cause that's the hardest thing about cycling my 357.

Rossi Rifleman

How much metal to take off??

How much metal to take off??

Re: How much metal to take off??

Re: How much metal to take off??

Re: How much metal to take off??

Re: How much metal to take off??

Re: How much metal to take off??

Re: How much metal to take off??