As noted in my 'cold turkey' thread, i have worked the ejector and spring. a couple questions...
1. The edges of the body of the ejector are rather sharp. Not burrs, but just sharp 90* angles. Can/should these be chamfered?
2. The spring I put in (from hardware store) is thinner wire thus weaker, and I cut it to match the length of the stock spring. Is it proper to cut another coil or two off to bring the ejector in a little more?
EDIT: Dumb. I"M DUMB. I originally wrote 'extractor'. I meant ejector...
A question about ejector and spring (edited)...
- jamesgpobog
- Posts: 114
- Joined: 03 Dec 2013 13:40
- Location: SoCal
- Has thanked: 5 times
- Been thanked: 13 times