Loaded up some stout loads. Slow cycled. Fast cycled. All is well and I think I can OFFICIALLY say this is solved/fixed. Hope no one else needs to go thru this but if they do THERE IS HOPE! a 1/16th roll pin and a .0620" drill bit.
Ejector guide pins
-
- Posts: 54
- Joined: 17 Feb 2016 19:20
- Location: Western NY
- Has thanked: 6 times
- Been thanked: 16 times
Re: Ejector guide pins
Andrew -M92 44 Mag 20" Oct Barrel with just about every possible problem fixed-Western NY-
- HarryAlonzo
- 500 Shots
- Posts: 989
- Joined: 31 Dec 2015 00:20
- Location: Sedona
- Has thanked: 248 times
- Been thanked: 281 times
Re: Ejector guide pins
Spiral pin or split pin? In either case, good application, and a fine outcome. Nice work!
-
- Posts: 54
- Joined: 17 Feb 2016 19:20
- Location: Western NY
- Has thanked: 6 times
- Been thanked: 16 times
Re: Ejector guide pins
Thank you HarryAlonzo, I went with a split pin. Found a pile of em out at work in the old shop and was given a few along with a couple .0620" drill bits.HarryAlonzo wrote:Spiral pin or split pin? In either case, good application, and a fine outcome. Nice work!
Andrew -M92 44 Mag 20" Oct Barrel with just about every possible problem fixed-Western NY-