I just installed gunfighter spring kit from Browells in my mod 92.
weigh tool was a berkly fish scale, dial face. use the numbers only as a reference point.
before after
rack action 8-9 down to 4.5-5
trigger 4.5 to 5 down to 2 to 2.4
very noticeable, very smooth.
My install did not go nearly so easily as on the utube video, but it works. no screws or springs left over, and be ready for a huge diference.
spring job
-
- Founding Member
- Posts: 96
- Joined: 24 Feb 2012 22:19
- Location: where arizona and callifornia meet
- Been thanked: 1 time
- Dan 444
- Founding Member
- Posts: 104
- Joined: 12 Feb 2012 18:36
- Location: Northern Adirondack Mountains
- Has thanked: 9 times
- Been thanked: 8 times
Re: spring job
That's where I like my trigger pull..........2.5 lbs. I try to set trigger pulls for all of my rifles at 2.5#, so that they feel consistent when I'm shooting more than one at the bench.
Dan
Dan
-
- Founding Member
- Posts: 96
- Joined: 24 Feb 2012 22:19
- Location: where arizona and callifornia meet
- Been thanked: 1 time
Re: spring job
Just a little more,
the ejecter rod must go thru the little collet, and collet must be allilgned with toothy part of the bolt or the rod will not go all the way in. also, if you can get the rod in all the way take the bolt pin that holds the lever to bolt, and slide it in. everytlhig goes easily after that. Also recommended is take some 400 grit and clean up the ejecter rod it self
Good luck and happy installing.
the ejecter rod must go thru the little collet, and collet must be allilgned with toothy part of the bolt or the rod will not go all the way in. also, if you can get the rod in all the way take the bolt pin that holds the lever to bolt, and slide it in. everytlhig goes easily after that. Also recommended is take some 400 grit and clean up the ejecter rod it self
Good luck and happy installing.