Right. It's nothing like wood glue, and epoxy needs a thin layer. My intention was to maybe help it push in to the fine sanding marks of the factory surface finish.Ohio3Wheels wrote:Just don't clamp so tight that you squeeze out all the "glue".
Make smoke,
Experimenting with JB Weld
-
- 250 Shots
- Posts: 344
- Joined: 19 Jan 2014 19:20
- Location: SW Ohio
- Has thanked: 61 times
- Been thanked: 65 times
Re: Experimenting with JB Weld
-
- 1000 Shots
- Posts: 1599
- Joined: 31 Jul 2014 15:18
- Location: Dayton Oh
- Has thanked: 227 times
- Been thanked: 328 times
Re: Experimenting with JB Weld
"Tooth" - not a bad idea at all
Make smoke,
Make smoke,
Curt... makin' smoke and raising my carbon foot print one cartridge at a time
-
- 250 Shots
- Posts: 261
- Joined: 09 Dec 2012 09:38
- Location: Bainbridge GA
- Has thanked: 10 times
- Been thanked: 21 times
Re: Experimenting with JB Weld
Simmons Gun Repair has a glue they use to put vent ribs on shotguns. Years ago I used it to put a Contender scope base on a .303 Enfield #4 barrel and added a scout scope. It held up just fine for many years.
-
- Posts: 239
- Joined: 18 Oct 2015 15:00
- Location: Washington
- Has thanked: 26 times
- Been thanked: 78 times
Re: Experimenting with JB Weld
Personally I would mark the barrel where the mount will go. Then tape it off and lightly sand blast it. Sand blast the bottom of the mount as well. Then clean the parts with carb cleaner as before. When applying the epoxy, pit a thin layer on both pieces. Use a popsicle stick to smear the epoxy into all the pits from the sand blasting. That's how I make my knives. I also add mechanical fasteners to the knife handles, but that doesn't apply here.
-
- 250 Shots
- Posts: 344
- Joined: 19 Jan 2014 19:20
- Location: SW Ohio
- Has thanked: 61 times
- Been thanked: 65 times
Re: Experimenting with JB Weld
Thanks, that would be a great method. When I assembled golf clubs I roughed up the shaft with 50 grit sandpaper.dvw86 wrote:Personally I would mark the barrel where the mount will go. Then tape it off and lightly sand blast it. Sand blast the bottom of the mount as well. Then clean the parts with carb cleaner as before. When applying the epoxy, pit a thin layer on both pieces. Use a popsicle stick to smear the epoxy into all the pits from the sand blasting. That's how I make my knives. I also add mechanical fasteners to the knife handles, but that doesn't apply here.
But, what I'm trying to do here is find a level of adhesion on the factory finish that will hold securely yet still allow me to remove the mount without damage if I ever want to sell the rifle. I can roughen up the barrel under the rear sight and then touch up with cold blue and it would not be noticeable. Combine that with a bolt in the dovetail slot and think it will hold.
Ironhead - Any idea what that stuff was called? I couldn't find it on their website.