Page 1 of 1

How to remove a stock from a single shot

Posted: 02 Sep 2016 07:52
by sherman
How do I revmove a stock from a Rossi single shot rifle ? What size bolt holds the stock on to the frame ? Is it metic or standard ?

Re: How to remove a stock from a single shot

Posted: 02 Sep 2016 14:44
by SAN14
First, remove the butt pad. The bolt can then be seen deep down in the hole drilled in the buttstock. I can't remember the size of the bolt head, but it unscrews just like any other bolt. I find it best to hold the frame in a padded vise when I remove the buttstocks on these type of rifles and shotguns.

Re: How to remove a stock from a single shot

Posted: 02 Sep 2016 17:36
by GasGuzzler
11mm and 7/16" are the same.
13mm and 1/2" are the same.
14mm and 9/16" are very close.
16mm and 5/8" are the same.
I bet it's one of those.

Re: How to remove a stock from a single shot

Posted: 02 Sep 2016 19:14
by Ranch Dog
I wanted to say that it is a 7/16"-11mm

Re: How to remove a stock from a single shot

Posted: 04 Sep 2016 07:37
by sherman
Thank You all very much

Re: How to remove a stock from a single shot

Posted: 04 Sep 2016 18:21
by Archer
I'd have said 13mm and 1/2" were very close.
Having had a mid 80s vehicle with a mix of standard and metric on it I know a half inch bolt is too large for a 12mm and a 13mm 12 point is pretty loose on it.