How to remove a stock from a single shot

Value priced adult & youth top break handguns, rifles, & shotguns chambered for centerfire & rimfire cartridges as well as shotshells. These arms are offered as single chamberings as well as a Matched Pair, Pick Four combinations, Trifecta, & the Wizard.
Post Reply
sherman
Posts: 37
Joined: 03 Nov 2013 11:46
Location: sumter sc
Been thanked: 3 times

How to remove a stock from a single shot

Post by sherman »

How do I revmove a stock from a Rossi single shot rifle ? What size bolt holds the stock on to the frame ? Is it metic or standard ?
SAN14
Posts: 15
Joined: 30 Nov 2014 14:22
Location: Ca./ USA
Been thanked: 1 time

Re: How to remove a stock from a single shot

Post by SAN14 »

First, remove the butt pad. The bolt can then be seen deep down in the hole drilled in the buttstock. I can't remember the size of the bolt head, but it unscrews just like any other bolt. I find it best to hold the frame in a padded vise when I remove the buttstocks on these type of rifles and shotguns.
User avatar
GasGuzzler
Moderator
Moderator
Posts: 2745
Joined: 02 Nov 2015 19:54
Location: Cooke County, TX
Has thanked: 310 times
Been thanked: 451 times

Re: How to remove a stock from a single shot

Post by GasGuzzler »

11mm and 7/16" are the same.
13mm and 1/2" are the same.
14mm and 9/16" are very close.
16mm and 5/8" are the same.
I bet it's one of those.
__________________________________________________________________________________________
I've always been crazy but it's kept me from going insane.
User avatar
Ranch Dog
Site Admin
Site Admin
Posts: 9398
Joined: 23 Jan 2012 07:44
Location: Inez, TX
Has thanked: 1837 times
Been thanked: 2281 times

Re: How to remove a stock from a single shot

Post by Ranch Dog »

I wanted to say that it is a 7/16"-11mm
Michael
Image
sherman
Posts: 37
Joined: 03 Nov 2013 11:46
Location: sumter sc
Been thanked: 3 times

Re: How to remove a stock from a single shot

Post by sherman »

Thank You all very much
Archer
2000 Shots
2000 Shots
Posts: 3942
Joined: 04 Feb 2014 05:30
Location: SoCal Loco
Has thanked: 137 times
Been thanked: 610 times

Re: How to remove a stock from a single shot

Post by Archer »

I'd have said 13mm and 1/2" were very close.
Having had a mid 80s vehicle with a mix of standard and metric on it I know a half inch bolt is too large for a 12mm and a 13mm 12 point is pretty loose on it.
Post Reply